How To Repair A Garden Hose Leak

Download Article

Download Article

It's happened many times before: you pull your garden hose out from the garage, screw it onto the faucet, attach that spiffy nozzle you got from the hardware store, turned on the water, and got soaked as the leaky hose gushed h2o all over y'all. Instead of replacing that hose, consider some simple methods to mend it.

Steps Download Commodity

1. 

   1

   Locate the leaks. If it didn't eject you in the face, y'all may have to keep a hole hunt. Does your hose leak at the faucet? Does it leak where you've joined two hoses? Does it leak at the point where you've fastened a sprinkler head or spraying device? Or does it leak somewhere in the middle?^[1]

2. 

   two

   Fix leaky joints. Disassemble the hose from other hoses or devices, and thoroughly lube the threads of each with petroleum jelly.

   • Reattach and you lot will notice fewer leaks, or even none at all. Exist careful trying to reattach the items every bit your hands volition be slick.
   • Another option is to use a rubber washer. These are bachelor at a hardware or garden supply store and tin can be slipped onto the "female" end of the hose. This should prevent leaking when it is joined to another hose or device.^[2]

   Advertisement

3. 

   3

   Use prophylactic cement for tears or punctures. ^[3]

   • Using a dry out paper towel, dry off the section of hose where in that location is a hole or cut. If the pigsty is inside a foot (30 cm) of the end of the hose, endeavor using a slice of dowel with paper towel wrapped around it to clean the inside of the hose.
   • Utilize some rubber cement to — and around — the hole. Fill in the hole, only non so much that information technology gets inside of the hose. This could result in clogging up the hose, and increasing the water'southward force per unit area, causing more than leaks and an incentive for the hose to burst at that weak spot.

4. 

   4

   Use a tire puncture repair kit. These are most ordinarily sold at cycle repair shops, body shops, car-part stores, etc.^[4]

   • Carefully read the directions of use, and employ the repair substance to the hole.
   • After drying, buy a small canvas of solid rubber from a craft shop, hardware shop or other supplier. You tin can likewise cut a small foursquare out of an old rubber pelting boot, bicycle tire, or whatever other rubber particular y'all no longer use.
   • Glue it over the leak and let dry (use a glue able to keep the prophylactic attached strongly

5. 

   five

   Get a coupling for more severe tears. They are available at a hardware store. Repair couplings piece of work by assuasive y'all to cut out the leaky portion of hose and re-join information technology where you made the cuts.^[5]

   • Shutoff the h2o to the hose and cut out the bad portion.
   • Splice in the repair coupling. It will accept detailed instructions on the label.

6. 

   half dozen

   Finished. At present go dry out yourself off!

Advertisement

Add together New Question

• Question

  How do I clean a blackness rubber garden hose so the black doesn't come off on my easily?

  

  You tin can lightly sand the hose to remove the oxidized surface. Or, you can try painting it with an elastomeric paint, if the sanding doesn't work.

• Question

  Can a garden hose be used like a ophidian to button a clog down a toilet?

  

  Sort of, yeah. You'd actually employ a nozzle on the hose to let its water stream suspension upwards the clog. If the clog is deeper in the plumbing system, then simply keep shoving the hose in while information technology'southward set up to its strongest stream to flush out and break upward anything in its path.

• Question

  How can I repair an expanding hose piping when it is in the middle of the hose?

  

  Visit the hardware store and pick up a joiner and some hose clamps. Then, cutting out the bad section, loosely put the clamps on the hose, install the joiner into each pipe, and tighten the clamps. Exist careful non to over-tighten the clamps though.

• Question

  Is it OK for me to leave the outside water faucet on when the attached hose is airtight?

  

  Well, information technology depends! If you are in a freeze prone region you should always discipline yourself to physically disconnect the hose from the bib fifty-fifty if you accept turned the bib off, specially in the fall. If yous go a hard freeze, the water will aggrandize and damage the bib. It won't be evident until you turn the hose back on in the spring, and and so y'all will be treated to a nasty surprise. The damaged bib will begin leaking into your basement, garage, or inside wall! Just make sure you see no leaks if you lot choose to leave the outside bib open!

• Question

  How do I fit a new garden hose on a tight plumbing equipment?

  

  Dip the cease in very hot water to soften it first, and then push it on while it is still soft.

• Question

  Can I utilize E6000 or rubber cement to stop a hose from spraying at the faucet?

  

  Joshua Pantoja-Lindsey

  Community Answer

  I would say no. If the leak is occurring effectually where the male and female person ends see (hose attaching to the faucet) grab some PTFE thread tape, commonly used for plumbing. Wrap that around the male end (probably the faucet tip) in the management that you will twist in order to rethread the connexion together. If it is in the faucet (where the knob is) then you likely need to unscrew the knob and supplant a washer or replace the faucet itself.

Ask a Question

200 characters left

Include your email address to get a bulletin when this question is answered.

Submit

Advertisement

Video

• Earlier trying to set your hose, see if the shop or supplier you lot bought it from will replace information technology for yous. It always pays to keep your receipt.

Advertizing

• If you apply "Super glue" or other strong agglutinative, be very conscientious because information technology tin actually stick your fingers together or even your hands.

• Exercise not burn down yourself with estrus gun if you employ ane.

Advertisement

Things You lot'll Demand

• Superglue
• Tire repair kit
• Rubber cement
• Safety square (from rain boot or purchased piece)
• Hose splice kit
• Rubber washers

Near This Article

Thanks to all authors for creating a page that has been read 237,008 times.

Did this article help you?

Source: https://www.wikihow.com/Fix-a-Garden-Hose

Share this post